Tenergy Battery Packs
Skip to end of metadata
Go to start of metadata


When you receive the kit, you should have 1 charger and 2 batteries with a connector.


When you charge the batteries, make sure the charger is on the 0.9A setting.


Using a small screwdriver, remove the leads from one battery pack. NOTE: you can only charge
one battery pack at a time!!! Attach the alligator clips to the battery pack as shown. Once the
pack is charged, the green light will come on and be steady. While charging the red light will
be on.


This configuration shown is used to put the batteries in series, giving us ~14V. Not the gray
wire on the middle two pins that connect the red of one battery to the black of the other. Make
sure NOT to cross the two outside wires, or sparking will occur!

Labels
  • No labels